Command (Function)
Advanced Operation
Setting the response
| SYST:CONF:RESP | Sets the response |
|---|
Configuring the synchronization function
| FREQ:SYNC | Turns the synchronization function on and off |
|---|---|
| FREQ:SYNC:PHASE:DEL | Sets the synchronization delay phase angle |
Setting the compensation function
| SYST:CONF:SENS:MODE | Sets the compensation function |
|---|
Configuring special waveform output
| WAVE:BANK | Specifies the number of the waveform bank that you want to execute |
|---|---|
| WAVE:EDIT:PCL | Sets the special waveform to the sine wave or a peak-clipped waveform, and sets the crest factor |
| WAVE:EDIT:USER:DATA:POIN | Sets a user-defined waveform |
| WAVE:BANK:TYPE | Queries the output waveform type |
| WAVE:EDOT:SIN | Sets the special waveform to the sine wave |
Configuring the output impedance
| OUTP:IMP | Sets the output impedance control |
|---|---|
| OUTP:IMP:LEVEL | Sets the output impedance in terms of resistance |
| OUTP:IMP:RAT | Sets the output impedance in terms of percentage |
Configuring soft starts
| OUTP:SST | Sets the soft start control |
|---|---|
| OUTP:SST:TIME | Sets the rise time |
Configuring the internal Vcc voltage
| VOLT:VCC:MODE | Sets the Vcc operating condition |
|---|---|
| VOLT:VCC | Sets the internal Vcc voltage |
Setting the ecological function
| SYST:CONF:POW:EXP | Sets the anticipated maximum power |
|---|
Advanced Operation
(Single-phase, three-wire output/ Three-phase output)
| SYST:CONF:POW{1|2|3}:EXP | Sets the anticipated maximum power of each phase |
|---|---|
| SYST:CONF:TPH:MODE | Sets the output mode (2P05-PCR-LE only) |
| WAVE{1|2|3}:EDIT:USER:DATA:POIN | Sets a user-defined waveform of each phase |
Advanced Operation (Master-Slave operation)
| SENS:CURR:ADJ:ZERO | Starts zero calibration |
|---|
Advanced Operation (Analog signal operation)
| FUNC:SOUR | Sets the signal source (EX05-PCR-LE only) |
|---|---|
| VOLT:EXT:SOUR | Sets the signal source (EX06-PCR-LE only) |
| SYST:CONF:EXT:SINP{[0]|1|2|3}:POL | Sets the polarity (EX05-PCR-LE only) |
| OUTP:EXT:LOG | Sets the logic of the output on/off |
| PROG:EXT:LOG | Sets the logic of the sequence start/stop |
| SYST:CONF:EXT:ACL | Sets the logic of the alarm clear |
| SYST:CONF:EXT:SHUT:CONT | Sets the logic of the shut down |
| SYST:CONF:EXT:OOR:MODE | Sets the phase to monitor. |
AC Power Supply PCR-LE series