Command (Subsystem)
PROGram subsystem
| PROG:EDIT | Edits a sequence step (excluding the jump, impedance, and phase settings) |
|---|---|
| PROG:EDIT:JUMP | Edits the jump settings of a sequence step |
| PROG:EDIT:OIMP:RAT | Edits the output impedance settings of a sequence step |
| PROG:EDIT:PHAS:STAR | Edits the starting phase angle settings and the phase change setting of a sequence step |
| PROG:EDIT:PHAS:STOP | Edits the ending phase angle settings of a sequence step |
| PROG:EDIT:PHAS:UOFF | Sets the U phase offset of the sequence |
| PROG:EDIT:PHAS:UV | Sets the U-V phase difference of a sequence step |
| PROG:EDIT:PHAS:UW | Sets the U-W phase difference of a sequence step (3P05-PCR-LE only) |
| PROG:EDIT:PHAS:RAMP | Sets the phase change |
| PROG:EDIT:VOLT{0|1|2|3} | Sets the unbalanced AC voltage of a sequence step |
| PROG:EDIT:VOLT{0|1|2|3}:OFFS | Sets the unbalanced DC voltage of a sequence step |
| PROG:LOOP | Sets the number of sequence repetitions |
| PROG:CLE | Sets all the steps in the sequence to their default values |
| PROG:STEP:STAR | Sets the sequence starting step number |
| PROG:STEP:END | Sets the sequence ending step number |
| PROG:EXEC | Queries the execution state of the sequence |
| PROG:STAT | Changes the execution state of the sequence |
PROGram subsystem (Analog signal operation)
| PROG:EXT:LOG | Sets the logic of the sequence start/stop |
|---|
AC Power Supply PCR-LE series