Command (Function)
Triggered Control of Output
The second level nodes are SEQuence[1] and TRANsient. Regardless of which node you use, the PCR operates in the same way when it receives the commands.
| VOLT:TRIG | Sets the AC voltage that will be set when a trigger is received |
|---|---|
| VOLT{1|2|3}:TRIG | Sets the AC voltage of each phase that will be set when a trigger is received |
| VOLT:MODE | Sets the trigger function control of the AC voltage setting |
| VOLT:OFFS:TRIG | Sets the DC voltage that will be set when a trigger is received |
| VOLT{1|2|3}:OFFS:TRIG | Sets the DC voltage of each phase that will be set when a trigger is received |
| VOLT:OFFS:MODE | Sets the trigger function control of the DC voltage setting |
| FREQ:TRIG | Sets the frequency that will be set when a trigger is received |
| FREQ:MODE | Sets the trigger function control of the frequency setting |
| WAVE:BANK:TRIG | Sets the number of the waveform bank that will be set when a trigger is received |
| WAVE:BANK:MODE | Sets the trigger function control of the number of the waveform bank |
| TRIG:SOUR | Sets the trigger source of the sequence 1 group |
| INIT | Starts the trigger function of the sequence 1 group |
| INIT:NAME | Starts the trigger function of the specified sequence group |
| TRIG | Sequence 1 group software trigger |
| ABOR | Aborts the trigger function |
AC Power Supply PCR-LE series