OUTP:IMP
Sets whether to set the output impedance.
Use OUTP:IMP:LEVEL or OUTP:IMP:RAT to set the output impedance.
This command is valid when the compensation function is not being used (SYST:CONF:SENS:MODE OFF).
Command
OUTPut:IMPedance[:STATe] {ON|OFF|1|0}
OUTPut:IMPedance[:STATe]?
Parameter
| Value | ON(1) | The output impedance will be set. |
| OFF(0) | The output impedance will not be set (default). |
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
Response
Response
Returns whether the output impedance will be set in NR1 format in response to OUTP:IMP?.
AC Power Supply PCR-LE series