Command (Subsystem)
SYSTem subsystem
| SYST:CONF:DATE | Sets the date |
|---|---|
| SYST:CONF:PHAS:UOFF:INIT | Clears the U phase offset setting. |
| SYST:CONF:PHAS:UV | Sets the U-V phase difference |
| SYST:CONF:PHAS:UW | Sets the U-W phase difference |
| SYST:CONF:POW:EXP | Sets the anticipated maximum power |
| SYST:CONF:POW{1|2|3}:EXP | Sets the anticipated maximum power of each phase |
| SYST:CONF:RESP | Sets the response |
| SYST:CONF:SENS:MODE | Sets the compensation function |
| SYST:CONF:SSUP | Sets the voltege surge suppression |
| SYST:CONF:STAT:OUTP:POL | Sets the status signal output polarity |
| SYST:CONF:TIME | Sets the time |
| SYST:CONF:TRIG:INP:POL | Sets the trigger signal input polarity |
| SYST:CONF:TRIG:OUTP:POL | Sets the trigger signal output polarity |
| SYST:CONF:TRAC | Sets the communication error display |
| SYST:CONF:WIR | Sets the output mode | SYST:CONF:WIR:CAT | Queries the output mode that the PCR-LE2 series can change to without power recycling. |
| SYST:ERR | Reads error information |
| SYST:KLOC | Locks panel controls |
| SYST:LOC | Switches the PCR to local mode |
| SYST:OPT | Queries the optional interface |
| SYST:REM | Switches the PCR to remote mode; locks panel controls (except the local key) |
| SYST:RWL | Switches the PCR to remote mode; locks panel controls |
| SYST:SLE | Turns the sleep function on and off |
| SYST:SLE:EXEC | Activates sleep mode immediately |
| SYST:SLE:TIME | Sets the time that must elapse before the product enters sleep mode |
| SYST:VERS | Queries the SCPI specification version that the PCR complies with |
SYSTem subsystem (Analog signal operation)
| SYST:CONF:EXT:SINP{[0]|1|2|3}:POL | Sets the polarity (EX05-PCR-LE only) |
|---|---|
| SYST:CONF:EXT:ACL | Sets the logic of the alarm clear |
| SYST:CONF:EXT:SHUT:CONT | Sets the logic of the shut down |
| SYST:CONF:EXT:OOR:MODE | Sets the phase to monitor. |
AC Power Supply PCR-LE series