SYST:CONF:SENS:MODE
Sets the compensation (voltage compensation) function.
This command is not valid when the output is on (OUTP ON).
This command is not valid when the output impedance is being set (OUTP:IMP ON).
Command
SYSTem:CONFigure:SENSing:MODE {OFF|SENS1|SENS2|RADJust}
SYSTem:CONFigure:SENSing:MODE?
Parameter
| Value | OFF | The compensation function is not used (default). |
| SENS1 | The hard sensing function is used. This parameter is not valid when the response is set to normal speed or high speed (SYST:CONF:RESP MED|FAST). |
|
| SENS2 | The soft sensing function is used. This parameter is not valid in the following situations: When the action that is performed when the current limit is exceeded is CC (CURR:PROT:STAT OFF). When a waveform bank is being used (WAVE:BANK is set to a value other than 0). When soft starts are enabled (OUTP:SST ON). When the output mode is AC+DC (OUTP:COUP ACDC). If the EX05-PCR-LE is in use (optional) and the signal source is set to external signal source or internal signal source plus external signal source (FUNC:SOUR EXT|SUM), this command is invalid. |
|
| RADJust | The regulation adjustment function is used. This parameter is not valid in the following situations: When the action that is performed when the current limit is exceeded is CC (CURR:PROT:STAT OFF). When a waveform bank is being used (WAVE:BANK is set to a value other than 0). When soft starts are enabled (OUTP:SST ON). When the output mode is DC (OUTP:COUP DC). When the output mode is AC+DC (OUTP:COUP ACDC). If the EX05-PCR-LE is in use (optional) and the signal source is set to external signal source or internal signal source plus external signal source (FUNC:SOUR EXT|SUM), this command is invalid. |
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
Response
Response
Returns the compensation function setting in CHAR format in response to SYST:CONF:SENS:MODE?.
AC Power Supply PCR-LE series