Command (Function)
Power Line Abnormality Simulations
The second level nodes are SEQuence4 and SIMulation. Regardless of which node you use, the PCR operates in the same way when it receives the commands.
Power line abnormality simulations are enabled in AC mode (OUTP:COUP AC).
Configuring power line abnormality simulations
| SIM:T1:PHAS:STAT | Selects the voltage regulation start (time or phase) |
|---|---|
| SIM:T1:TIME | Sets the voltage regulation starting time |
| SIM:T1:PHAS | Sets the voltage regulation starting phase |
| SIM:T2:TIME | Sets slope time 1 |
| SIM:T3:TIME | Sets the voltage regulation time |
| SIM:T3:VOLT | Sets the regulated voltage |
| SIM:T4:TIME | Sets slope time 2 |
| SIM:T5:CYCL:STAT | Selects the duration that the voltage remains at the initial level (time or cycles) |
| SIM:T5:TIME | Sets the return time |
| SIM:T5:CYCL | Sets the return cycles |
| SIM:POL | Sets the voltage regulation polarity |
| SIM:REP:COUN | Sets the number of repetitions |
| SYST:CONF:STAT:OUTP:POL | Sets the status signal output polarity |
Executing power line abnormality simulations
| SIM:STAT | Executes and stops power line abnormality simulations |
|---|---|
| SIM:EXEC | Queries the execution status of power line abnormality simulations |
| TRIG:SEQ4:SOUR TRIG:SIM:SOUR |
Sets the trigger source of the sequence 4 group |
| INIT:SEQ4 | Starts the trigger function of the sequence 4 group |
| INIT:NAME | Starts the trigger function of the specified sequence group |
| TRIG:SEQ4 TRIG:SIM |
Sequence 4 group software trigger |
| ABOR | Aborts the trigger function |
AC Power Supply PCR-LE series