SYST:CONF:TPH:MODE
Sets the output mode for single-phase, three-phase output.
This command is valid in AC mode (OUTP:COUP AC).
This command is not valid when the output is on (OUTP ON).
This command is valid in single-phase three-wire output (PCR-LE optional).
Command
SYSTem:CONFigure:TPHase:MODE {ON|OFF|1|0}
SYSTem:CONFigure:TPHase:MODE?
Parameter
| Value | ON(1) | Double-phase output |
| OFF(0) | Single-phase three-wire output |
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
Response
Response
Returns the output mode in NR1 format in response to SYST:CONF:TPH:MODE?.
AC Power Supply PCR-LE series