WAVE:BANK
Specifies the number of the waveform bank that you want to execute.
This command is valid in AC mode and AC+DC mode (OUTP:COUP AC|ACDC).
This command is not valid when the synchronization function is in use (FREQ:SYNC ON).
This command is not valid if you have set the compensation function to the soft sensing function or the regulation adjustment function (SYST:CONF:SENS:MODE SENS2|RADJ).
If the EX05-PCR-LE is in use (optional) and the signal source is set to external signal source (FUNC:SOUR EXT), this command is invalid.
During single-phase, three-wire output and three-phase output (optional), the same waveform is assigned to all phases.
Command
[SOURce:]WAVE:BANK[:SELect] <NR1>
[SOURce:]WAVE:BANK[:SELect]?
Parameter
| Value | 0 to 63 (0 by default) |
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
Response
Returns the presently specified waveform bank number in NR1 format in response to WAVE:BANK?.
AC Power Supply PCR-LE series