The parameter format of SCPI is derived from the program parameter format defined in IEEE 488.2.
The representation system of the program data that is used on the PCR is indicated below.
Non-numeric parameters
Character string data (String)
Used when a series of ASCII characters are requested.
Be sure to enclose a string in single or double quotation marks. The start and end quotation marks must match.
DISPlay:AMMeter "AVG"
If you wish to use a quotation mark as a part of the string, enter two quotation marks consecutively (with no characters in between).
Character data is used when only a limited number of values are available for the program setting. Responses are returned in the short form.
TRIGger:SOURce {BUS|IMMediate}
Boolean data expresses a 1 or 0 condition or an ON or OFF condition. Responses are returned as 1 or 0.
OUTPut {ON|OFF|1|0}
Numeric parameters
Represents an integer.
Details are given in the IEEE 488.2 Standard Digital Interface for Programmable Instrumentation.
Represents a real number (floating point).
Details are given in the IEEE 488.2 Standard Digital Interface for Programmable Instrumentation.
Represents a real number (exponential).
Details are given in the IEEE 488.2 Standard Digital Interface for Programmable Instrumentation.
The value +3.80000E+02 is returned for the response data 380. The number of digits to the right of the decimal is 5.
NRf is a generic term that includes NR1, NR2, and NR3.
A numeric parameter such as a decimal point, optional prefix, or measurement unit.
The syntax as a numeric representation is the same as NRf.
MINimum and MAXimum are available as substitutes for declaring certain values.
Units such as V, A, and W can also be used in a numeric parameter.
If a value that cannot be assigned is entered, the device rounds the value to the closest possible value.
SOURce:FREQuency 1100
PCR-M: The range of values for frequency is 40 to 500. Thus, 500 is set even if 1100 is specified.
PCR-LE/PCR-LE2: The range of values for frequency is 1 to 999.9. Thus, 999.9 is set even if 1100 is specified.
Special form numeric parameters
The special form numeric parameters MINimum, MAXimum and DEFault can be used as substitutes for limit values when the parameter is numeric.
In the example below, the current limit is set to the minimum value.
SOURce:CURRent MINimum
Queries can be used to inquire the minimum and maximum values for most parameters.
SOURce:CURRent? MAX
SOURce:CURRent? MIN
Measurement units
Below are the default measurement units. Commands are accepted even if measurement units are not specified.
| ·V（voltage） | ·A（current） | ·W (wattage) | ·VA (apparent power) |
| ·VAR (reactive power) | ·DEG (degrees) | ·HZ (frequency) |
The following optional prefixes are supported. If you use optional prefixes, specify the measurement unit.
·M （milli） ·K （kilo） ·U （micro）
NOTE
| · The unit symbols in the International System of Units (SI) contain lowercase characters. The IEEE standard uses uppercase characters. SCPI commands are not case-sensitive. |
| · Commands are accepted even if a measurement unit is not specified. |
| · To enter "µ" in the data, use "U" instead. |
AC Power Supply PCR-LE series