Command (Function)
Output Settings
Setting the Output
| OUTP:COUP | Sets the output mode |
|---|
Setting the output method
| SYST:CONF:WIR | Sets the output mode | SYST:CONF:WIR:CAT | The output mode setting is valid when power cycling is not necessary. |
|---|
Output on/off
| OUTP | Output on/off |
|---|---|
| OUTP:PON | Output status at power-on |
Setting the output on/off phase angle
| OUTP:PHAS:ON | Sets the output on phase control |
|---|---|
| OUTP:PHAS:ON:LEV | Sets the output on phase angle |
| OUTP:PHAS:OFF | Sets the output off phase control |
| OUTP:PHAS:OFF:LEV | Sets the output off phase angle |
Setting the voltage surge suppression
| SYST:CONF:SSUP | Sets the voltege surge suppression |
|---|
Setting the voltage
| VOLT:RANG | Sets the voltage range |
|---|---|
| VOLT | Sets the AC voltage |
| VOLT:OFFS | Sets the DC voltage |
| VOLT{1|2|3} | Sets the AC voltage of each phase |
| VOLT{1|2|3}:OFFS | Sets the DC voltage of each phase |
| VOLT:LINE | Sets the AC line voltage |
| VOLT:OFFS:LINE | Sets the DC line voltage |
| SYST:CONF:PHAS:UV | Sets the U-V phase difference |
| SYST:CONF:PHAS:UW | Sets the U-W phase difference |
Setting the frequency
| FREQ | Sets the frequency |
|---|
AC Power Supply PCR-LE series