PROG:EDIT:PHAS:STAR
Configures the starting phase angle settings and the phase change setting of a sequence step.
Command
PROGram:EDIT:PHASe:STARt <step_NR1>,<enable_bool>[,<phase_numeric>[,<phase_change_bool>]]
PROGra:EDIT:PHASe:STARt? <step_NR1>
Parameter <step_NR1>
| Value | 0 to 599 | Number of the step that you want to configure |
Parameter <enable_bool> {ON|OFF|1|0}
| Value | ON(1) | Enables phase control |
| OFF(0) | Disables phase control |
Parameter <phase_numeric> {numeric|MAXimum|MINimum}
| Value | 0 to 359 | Starting phase angle |
| Unit | DEG | |
Parameter <phase_change_bool> {ON|OFF|1|0}
| Value | ON(1) | Enables phase change |
| OFF(0) | Disables phase change |
Response
Returns the starting phase angle settings and the phase change setting of the specified step in the following order in response to PROG:EDIT:PHAS:STAR? <step_NR1>.
Whether the phase is controlled <NR1>,starting phase angle <NR3>, phase change setting<NR1>
AC Power Supply PCR-LE series