PROG:EDIT:OIMP:RAT
Configures the output impedance settings (as a percentage) of a sequence step.
Command
PROGram:EDIT:OIMPedance:RATio <step_NR1>,<enable_bool>,{<ratio_numeric>|MAXimum|MINimum}
PROGram:EDIT:OIMPedance:RATio? <step_NR1> [{MAXimum|MINimum}]
Parameter <step_NR1>
| Value | 0 to 599 | Number of the step that you want to configure |
Parameter <enable_bool> {ON|OFF|1|0}
| Value | ON(1) | The output impedance will be set. |
| OFF(0) | The output impedance will not be set. |
Parameter <ratio_numeric>
| Value | 1 to 100 | Output impedance |
| Unit | PCT | |
Response
Returns the output impedance settings of the specified step in the following order in response to PROG:EDIT:OIMP:RAT? <step_NR1>.
Whether the output impedance will be set <NR1>,output impedance <NR3>
AC Power Supply PCR-LE series