PROG:EDIT:PHAS:UV
Configures the U-V phase difference settings of a sequence step.
This command is valid in single-phase three-wire output or three-phase output (PCR-LE optional).
Command
PROGram:EDIT:PHASe:UV <step_NR1>,<enable_bool>,[<phase_numeric>]
PROGram:EDIT:PHASe:UV? <step_NR1>
Parameter <step_NR1>
| Value | 0 to 599 | Number of the step that you want to configure |
Parameter <enable_bool> {ON|OFF|1|0}
| Value | ON(1) | Enables U-V phase difference control |
| OFF(0) | Disables U-V phase difference control |
Parameter <phase_numeric> {numeric|MAXimum|MINimum}
| Value | 0 to 359 | U-V phase difference angle |
| Unit | DEG | |
Response
Returns the U-V phase difference settings of the specified step in the following order in response to PROG:EDIT:PHAS:UV? <step_NR1>.
Whether the U-V phase difference is controlled <NR1>,U-V phase difference angle <NR3>
AC Power Supply PCR-LE series