PROG:EDIT:PHAS:STOP
Configures the ending phase angle settings of a sequence step.
Command
PROGram:EDIT:PHASe:STOP <step_NR1>,<enable_bool>,[<phase_numeric>]
PROGram:EDIT:PHASe:STOP? <step_NR1>
Parameter <step_NR1>
| Value | 0 to 599 | Number of the step that you want to configure |
Parameter <enable_bool> {ON|OFF|1|0}
| Value | ON(1) | Enables phase control |
| OFF(0) | Disables phase control |
Parameter <phase_numeric> {numeric|MAXimum|MINimum}
| Value | 0 to 359 | Ending phase angle |
| Unit | DEG | |
Response
Returns the ending phase angle settings of the specified step in the following order in response to PROG:EDIT:PHAS:STOP? <step_NR1>.
Whether the phase is controlled <NR1>,ending phase angle <NR3>
AC Power Supply PCR-LE series