PROG:EDIT:VOLT (PCR-LE/ PCR-LE2 only)

Configures the unbalanced AC voltage settings of a sequence step.

This command is valid in single-phase three-wire output or three-phase output (optional).

Command

All phases

PROGram:EDIT:VOLTage[0] <step_NR1>,<volt_numeric>

PROGram:EDIT:VOLTage[0]? <step_NR1>

U phase

PROGram:EDIT:VOLTage1 <step_NR1>,<volt_numeric>

PROGram:EDIT:VOLTage1? <step_NR1>

V phase

PROGram:EDIT:VOLTage2 <step_NR1>,<volt_numeric>

PROGram:EDIT:VOLTage2? <step_NR1>

W phase (Three-phase output only)

PROGram:EDIT:VOLTage3 <step_NR1>,<volt_numeric>

PROGram:EDIT:VOLTage3? <step_NR1>

Parameter <step_NR1>

Value

0 to 599

Number of the step that you want to configure

Parameter <volt_numeric> {numeric|MAXimum|MINimum}

Value	0 to 305	Unbalanced voltage
Unit	V

Response

In case of the single-phase three-wire output, PROG:EDIT:VOLT? <step_NR1> returns a comma-separated list of the AC voltage <NR3> of the specified step for U and V phases.

In case of the three-phase output, PROG:EDIT:VOLT? <step_NR1> returns a comma-separated list of the AC voltage <NR3> of the specified step for U, V, and W phases.

Returns the AC voltage in NR3 format of U phase of the specified step in response to PROG:EDIT:VOLT1? <step_NR1>.

Returns the AC voltage in NR3 format of V phase of the specified step in response to PROG:EDIT:VOLT2? <step_NR1>.

Returns the AC voltage in NR3 format of W phase of the specified step in response to PROG:EDIT:VOLT3? <step_NR1>.