PROG:EDIT:PHAS:UW
Configures the U-W phase difference settings of a sequence step.
This command is valid in three-phase output (PCR-LE optional).
Command
PROGram:EDIT:PHASe:UW <step_NR1>,<enable_bool>,[<phase_numeric>]
PROGram:EDIT:PHASe:UW? <step_NR1>
Parameter <step_NR1>
| Value | 0 to 599 | Number of the step that you want to configure |
Parameter <enable_bool> {ON|OFF|1|0}
| Value | ON(1) | Enables U-W phase difference control |
| OFF(0) | Disables U-W phase difference control |
Parameter <phase_numeric> {numeric|MAXimum|MINimum}
| Value | 0 to 359 | U-W phase difference angle |
| Unit | DEG | |
Response
Returns the U-W phase difference settings of the specified step in the following order in response to PROG:EDIT:PHAS:UW? <step_NR1>.
Whether the U-W phase difference is controlled <NR1>,U-W phase difference angle <NR3>
AC Power Supply PCR-LE series