PROG:EDIT (PCR-LE/ PCR-LE2 only)

Configures a sequence step (excluding the jump and impedance settings).

Command

PROGram:EDIT <step_NR1>,<freq-ramp_bool>,<freq_numeric>,
<acv-ramp_bool>,<acv_numeric>,<dcv-ramp_bool>,<dcv_numeric>,<time_numeric>,<bank_NR1>,
<status-out_bool>,<trig-out_bool>,<trig-in_bool>,<output_bool>

PROGram:EDIT? <step_NR1>

Parameter <step_NR1>

Value

0 to 599

Number of the step that you want to configure

Parameter <freq-ramp> {ON|OFF|1|0}

Value	ON(1)	Enables the ramped frequency transition
	OFF(0)	Disables the ramped frequency transition

Parameter <freq> {<numeric>|MAXimum|MINimum}

Value	1 to 999.9	Frequency
Unit	HZ

Parameter <acv-ramp> {ON|OFF|1|0}

Value	ON(1)	Enables the ramped AC voltage transition
	OFF(0)	Disables the ramped AC voltage transition

Parameter <acv> {<numeric>|MAXimum|MINimum}

Value	0 to 305.0	AC voltage*1
Unit	V

*1 During single-phase, three-wire output and three-phase output (optional), all phases are set at the same time.

Parameter <dcv-ramp> {ON|OFF|1|0}

Value	ON(1)	Enables the ramped DC voltage signal change
	OFF(0)	Disables the ramped DC voltage signal change

Parameter <dcv> {<numeric>|MAXimum|MINimum}

Value	0 to ±431.0	DC voltage (About the values for single-phase, three-wire output and three-phase output)
Unit	V

Parameter <time> {<numeric>|MAXimum|MINimum}

Value	0.0001s to 1000h	Step time
Unit	S

Parameter <bank_NR1>

Value

0 to 63

Number of the waveform bank to use

Parameter <status-out> {ON|OFF|1|0}

Value	ON(1)	Enables status output
	OFF(0)	Disables status output

Parameter <trig-out> {ON|OFF|1|0}

Value	ON(1)	Enables trigger output
	OFF(0)	Disables trigger output

Parameter <trig-in> {ON|OFF|1|0}

Value	ON(1)	Enables trigger input
	OFF(0)	Disables trigger input

Parameter <output> {ON|OFF|1|0}

Value	ON(1)	Enables output
	OFF(0)	Disables output

Response

Returns the settings of the specified step in the following order in response to PROG:EDIT? <step_NR1>.

Frequency signal change <NR1>,frequency <NR3>,AC voltage signal change <NR1>,AC voltage*2 <NR3>, DC voltage signal change <NR1>, DC voltage*3 <NC3>, step execution time <NR3>, waveform bank number <NR1>, status output <NR1>, trigger output <NR1>, trigger input <NR1>, output on/off <NR1>

*2 During single-phase, three-wire output and three-phase output (optional), the U phase AC voltage is returned when the unbalanced voltage is set.

*3 During two-phase output and three-phase output (optional), the U phase DC voltage is returned when the unbalanced voltage is set.