VOLT{1|2|3}

Sets the AC voltage of each phase.

This command is valid in single-phase three-wire output or three-phase output (PCR-LE optional).

This command is valid in AC mode (when the parameter to OUTP:COUP is AC).

If the EX05-PCR-LE is in use (optional) and the signal source is set to external signal source (FUNC:SOUR EXT), this command is invalid.

If the EX06-PCR-LE is in use (optional) and the AC voltage is being controlled with an external signal (VOLT:EXT:SOUR VOLT), this command is invalid.

Command

U phase

[SOURce:]VOLTage1[:LEVel][:IMMediate][:AMPLitude] {<numeric>|MINimum|MAXimum}

[SOURce:]VOLTage1[:LEVel][:IMMediate][:AMPLitude]? [{MINimum|MAXimum}]

V phase

[SOURce:]VOLTage2[:LEVel][:IMMediate][:AMPLitude] {<numeric>|MINimum|MAXimum}

[SOURce:]VOLTage2[:LEVel][:IMMediate][:AMPLitude]? [{MINimum|MAXimum}]

W phase (Three-phase output only)

[SOURce:]VOLTage3[:LEVel][:IMMediate][:AMPLitude] {<numeric>|MINimum|MAXimum}

[SOURce:]VOLTage3[:LEVel][:IMMediate][:AMPLitude]? [{MINimum|MAXimum}]

Parameter

Value	L range: 0 to 152.5 H range: 0 to 305.0   A SCPI error (-222, "Data out of range") occurs if outside the range. The default value is 0.
Unit	V

For the setting that is applied when *RST is sent, see this table

For the setting that is applied when *RST is sent, see this table

For the setting that is applied when *RST is sent, see this table

Response

Response

Returns the AC voltage setting of U phase in NR3 format in response to VOLT1?.

Returns the AC voltage setting of V phase in NR3 format in response to VOLT2?.

Returns the AC voltage setting of W phase in NR3 format in response to VOLT3?.