SIM:STAT
Executes or stops a power line abnormality simulation.
This command is valid in AC mode (OUTP:COUP AC).
This command is not valid when the output is off (OUTP OFF).
If the EX05-PCR-LE is in use (optional) and the signal source is set to external signal source (FUNC:SOUR EXT), this command is invalid.
If the EX06-PCR-LE is in use (optional) and the AC voltage is being controlled with an external signal (VOLT:EXT:SOUR VOLT), this command is invalid.
Command
SIMulation:STATe {STOP|RUN}
Parameter
| Value | STOP | Stops the power line abnormality simulation |
| RUN | Executes the power line abnormality simulation |
AC Power Supply PCR-LE series