SYST:SLE
Turns the sleep function on and off.
Even if the sleep function is turned off, you can activate the sleep function by sending the SYST:SLE:EXEC command.
Use SYST:SLE:TIME to set the time that must elapse before the PCR enters sleep mode.
Command
SYSTem:SLEep[:STATe] {ON|OFF|1|0}
SYSTem:SLEep[:STATe]?
Parameter
| Value | ON(1) | The sleep function is turned on. |
| OFF(0) | The sleep function is turned off (default). |
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
Response
Response
Returns whether the sleep function is on or off in NR1 format in response to SYST:SLE?.
AC Power Supply PCR-LE series