INIT
Starts the sequence group 1 trigger function.
If trigger source is set to IMM, the change starts immediately. If set to BUS, the change starts after waiting for a software trigger.
Command
INITiate[:IMMediate][:SEQuence[1]]
AC Power Supply PCR-LE series
AC Power Supply PCR-LE2 series
AC Power Supply PCR-M series
Commnunication Interface Mannual
- Introduction
- Installing the VISA library
- Interface Setup
- Overview of Command
- Parameters
- Default settings
- Default settings
- Default settings
Command (function search)
- IEEE488.2 Common Commands
- IEEE488.2 Common Commands
- Output Setting
- Output Setting
- Output Setting
- Protection and Clearing Alarms
- Protection and Clearing Alarms
- Protection and Clearing Alarms
- Advanced Operation
- Advanced Operation
- Display Function
- Display Function
- Memory Usage
- Triggered Control of Output
- Triggered Control of Output
- Triggered Control of Output
- Output On/Off Phase Control
- Output On/Off Phase Control
- Measured Value Queries
- Measured Value Queries
- Measured Value Queries
- Power Line Abnormality Simulations
- Sequence Operations
- Sequence Operations
- System Configuration
- System Configuration
- System Configuration
- Registers
- Registers
- Registers
Command (ABC search)
Command (Sub-system search)
- SOURce
- SOURce
- SOURce
- OUTPut
- OUTPut
- MEASure and FETCh
- MEASure and FETCh
- MEASure and FETCh
- TRIGger
- TRIGger
- PROGram
- PROGram
- SIMulation
- SYSTem
- SYSTem
- SYSTem
- STATus
- STATus
- STATus
- IEEE488.2 Common Commands
- IEEE488.2 Common Commands
- Other Commands
- Other Commands
- Other Commands
- List(PDF)
Register
Appendix
Tutorial
AC Power Supply PCR-LE series
Communication Interface Manual
AC Power Supply PCR-LE2 series
Communication Interface Manual
AC Power Supply PCR-M series
Communication Interface Manual