VOLT{1|2|3}:TRIG

Sets the AC voltage of each phase that is applied when INIT/INIT:NAME TRAN and a software trigger are sent.

This command is valid in AC mode (OUTP:COUP AC).

Single-phase three-wire output or Three-phase output (PCR-LE optional): Sets the AC voltage of all phases at once.

Command

U phase

[SOURce:]VOLTage1[:LEVel]:TRIGgered[:AMPLitude] {<numeric>|MINimum|MAXimum}

[SOURce:]VOLTage1[:LEVel]:TRIGgered[:AMPLitude]? [{MINimum|MAXimum}]

V phase

[SOURce:]VOLTage2[:LEVel]:TRIGgered[:AMPLitude] {<numeric>|MINimum|MAXimum}

[SOURce:]VOLTage2[:LEVel]:TRIGgered[:AMPLitude]? [{MINimum|MAXimum}]

W phase (Three-phase output only)

[SOURce:]VOLTage3[:LEVel]:TRIGgered[:AMPLitude] {<numeric>|MINimum|MAXimum}

[SOURce:]VOLTage3[:LEVel]:TRIGgered[:AMPLitude]? [{MINimum|MAXimum}]

Parameter

Value	L range: 0 to 152.5 H range: 0 to 305.0   A SCPI error (-222, "Data out of range") occurs if outside the range. The default value is 0.
Unit	V

For the setting that is applied when *RST is sent, see this table

For the setting that is applied when *RST is sent, see this table

For the setting that is applied when *RST is sent, see this table

Response

Response

Returns the  target value of U phase to which the AC voltage is to change using a trigger in NR3 format in response to VOLT1:TRIG?.

Returns the  target value of V phase to which the AC voltage is to change using a trigger in NR3 format in response to VOLT2:TRIG?.

Returns the  target value of W phase to which the AC voltage is to change using a trigger in NR3 format in response to VOLT3:TRIG?.