Command (function search)
Sequence operations
Program configuration
| PROG | Selects or deselects a program |
|---|---|
| PROG:CRE | Creates a new program of the specified name |
| PROG:CURR:PROT | Sets the current value for overcurrent protection (OCP) in the selected program |
| PROG:CURR:PROT:STAT PROG:CURR:PROT:ACT |
Sets the operation when overcurrent protection (OCP) is activated in the selected program |
| PROG:CVOP:LEV | Sets the voltage at +CV (addition of CV mode) application in the selected program |
| PROG:DEL | Deletes the program of the specified name |
| PROG:LIST? | Queries the list of registered programs |
| PROG:LOOP | Sets the number of times that the selected program will repeat |
| PROG:POW:PROT | Sets the power of overpower protection (OPP) in the selected program |
| PROG:POW:PROT:STAT PROG:POW:PROT:ACT |
Sets the operation to be performed when overpower protection (OPP) is activated in the selected program |
| PROG:REN | Changes the name of the selected program |
| PROG:SAVE | Saves the selected program |
| PROG:VOLT:PROT:LOW | Sets the voltage of underpower protection (UVP) in the selected program |
| PROG:VOLT:PROT:STAT | Enables/disables undervoltage protection (UVP) in the selected program |
| PROG:VOLT:PROT:ACT | Sets the operation to be performed when overpower protection (UVP) is activated in the selected program |
Step configuration
| PROG:STEP<n>:DWEL | Sets the step execution time at the specified step of the selected program |
|---|---|
| PROG:STEP<n>:INP | Sets load on/off at the specified step of the selected program |
| PROG:STEP<n>:LEV | Sets the load at the specified step of the selected program |
| PROG:STEP<n>:OUTP | Sets load on/off at the specified step of the selected program |
| PROG:STEP<n>:SLEW | Sets the slew rate at the specified step of the selected program |
| PROG:STEP<n>:TRAN | Sets the setting transition method at the specified step of the selected program |
| PROG:STEP<n>:TRIG:GEN | Sets whether to perform trigger output at the specified step of the selected program |
| PROG:STEP<n>:TRIG:WAIT | Sets trigger wait at the specified step of the selected program |
| PROG:STEPS:COUN | Sets the number of steps to be registered to the selected program |
Sequence execution
| INIT:TRAN:PROG | Switches to the sequence trigger wait state in the program selected by PROG |
|---|---|
| TRIG:ACQ:SOUR | Sets the measurement trigger source |
| TRIG:TRAN:SOUR | Sets the source of the trigger to be sent to TRANsient |
| ABOR | Aborts the trigger function |
| TRIG:TRAN:DEL | Sets the delay time for applying sequence triggers |
| TRIG:TRAN:SUSP | Pauses a sequence that is being executed |
| TRIG:TRAN:RES | Resumes a sequence that has been paused |
| TRIG:TRAN:EXEC? | Queries the execution state of the sequence trigger function and the pulse function |
| TRIG:TRAN:MSYN | Starts a sequence simultaneously on synchronized PLZ12005WH/PLZ20005WHs |
Electronic Load PLZ12005WH/PLZ20005WH