TRIG:TRAN:SOUR
Sets the trigger source for clearing sequence start trigger wait states.
Command
TRIGger:TRANsient:SOURce <character>
TRIGger:TRANsient:SOURce?
Parameter <character>
You can select from the available choices below.
| Value | IMMediate | Starts the sequence when the Initiate key on the PLZ12005WH/PLZ20005WH front panel is pressed or when INIT:TRAN:PROG is received from a PC or the like. |
|---|---|---|
| BUS | Starts execution at the timing of software trigger application by the 4882/SCPI command | |
| DIGITAL2 | Starts execution at the timing at which a signal is input to pin 13 of the EXT CONT connector of the PLZ12005WH/PLZ20005WH (when SYST:CONF:DIGITAL2:DIR is set to INPut). | |
| MSYNc | Starts the sequence when an MSync key on the front panel of the synchronized PLZ12005WH/PLZ20005WHs is pressed. Starts the sequence when TRIG:TRAN:MSYN is received from a PC or the like. | |
| LOADOFF | Executes the sequence when the load is turned off. | |
| *RST transmission | IMMediate |
Example
TRIG:TRAN:SOUR DIGITAL2
Response
Returns the source of the trigger to be applied for TRANsient in character format in response to the TRIG:TRAN:SOUR? query.
Electronic Load PLZ12005WH/PLZ20005WH