Command (Sub-system search)
SYSTem subsystem
| SYST:BEEP | Collectively sets the beep sounds on/off |
|---|---|
| SYST:BEEP:KEY | Sets whether a beep sound is generated in case of invalid operation |
| SYST:BEEP:PROT | Sets whether a beep sound is generated when a protection is activated |
| SYST:BEEP:SCPI | Sets whether a beep sound is generated in case of SCPI error |
| SYST:COMM:RLST | Sets the PLZ12005WH/PLZ20005WH to remote mode or local mode |
| SYST:CONF:DIGITAL2:DIR | Sets I/O direction of DIGITAL2 signal |
| SYST:CONF:MSYN:IND? | Queries whether mutual synchronization connection is enabled or disabled |
| SYST:CONF:RSEN | Sets remote sensing function on/off |
| SYST:DATE | Sets the date |
| SYST:ERR? | Reads error information |
| SYST:ERR:COUN? | Queries the number of unread errors |
| SYST:KLOC | Panel control lock |
| SYST:KLOC:LEV | Sets the lock level of panel operation |
| SYST:PASS | Enables a password-protected command and enables the execution of SYST:SEC:IMM. |
| SYST:PASS:CDIS | Disable the password-protected command and disables the execution of SYST:SEC:IMM. |
| SYST:PASS:NEW | Sets the password |
| SYST:PASS:STAT? | Queries whether a password-protected command is valid or invalid. |
| SYST:SEC:IMM | Deletes the user data according to the NISPOM requirements and restores the factory default settings |
| SYST:SSAV | Sets screen saver on/off |
| SYST:SSAV:DEL | Sets the time until the screen saver starts |
| SYST:TIME | Sets the time |
| SYST:TIME:ADJ | Automatically adjusts the system clock |
| SYST:TZON | Sets the time zone of the system clock |
| SYST:TZON:CAT? | Queries all the time zone IDs that can be used |
| SYST:VERS? | Queries the SCPI specification version that the PLZ12005WH/PLZ20005WH complies with |
Electronic Load PLZ12005WH/PLZ20005WH