PROG:STEP<n>:TRIG:WAIT
Sets trigger wait at the specified step of the program selected by PROG.
Command
[SOURce:]PROGram[:SELected]:STEP<n>:TRIGger:WAIT <character>[,<character>,<character>]
[SOURce:]PROGram[:SELected]:STEP<n>:TRIGger:WAIT?
Parameter <n>
| Value | Specifies the step number |
|---|---|
| Example | STEP1 |
Parameter <character>
If IMMediate or BUS is set, it cannot be specified at the same time as other setting values.
You can specify up to 3 items in the case of TRIGIN, DIGITAL2 and MSYNc.
| Value | IMMediate | Execution the step at the internal timing of the PLZ12005WH/PLZ20005WH without waiting for trigger application |
|---|---|---|
| BUS | Executes the step at the timing of software trigger (*TRG) application. The trigger is applied to both trigger systems: (1) sequence and step (TRANsient) and (2) measure (ACQuire). | |
| TRIGIN | Executes the step at the timing at which a signal is input to pin 9 of the EXT CONT connector of the PLZ12005WH/PLZ20005WH | |
| DIGITAL2 | Executes the step at the timing at which a signal is input to pin 13 of the EXT CONT connector of the PLZ12005WH/PLZ20005WH (when SYST:CONF:DIGITAL2:DIR is set to INPut) | |
| MSYNc | A step is executed when a signal (ACQuire command) is received from external equipment synchronized to the PLZ12005WH/PLZ20005WH or when a TRIG:ACQ:MSYN synchronization command packet is received from a PC or the like. |
Example
PROG:STEP1:TRIG:WAIT DIGITAL2,MSYNc
Response
Returns the trigger wait setting state at the specified step in character format in response to the PROG:STEP<n>:TRIG:WAIT? query.
Electronic Load PLZ12005WH/PLZ20005WH