Appendix
Command processing time
A certain amount of time is required before the commands shown in the following table are received by the PLZ12005WH/PLZ20005WH.
The processing times shown here are typical values, not guaranteed values.
The processing times vary depending on the settings and the measurement conditions. The values shown below include hardware response times.
| Command | Processing time (ms) | ||
|---|---|---|---|
| RS232C1 | USB | LAN | |
| INP/OUTP | 30 | 5 | 5 |
| CURR | 30 | 5 | 5 |
| INIT:TRAN:PROG | 30 | 5 | 5 |
| MEAS?2 | 180 | 130 | 130 |
1: Baud rate setting: 115200 bps
2: When SENS:APER is 0.1 second.
Electronic Load PLZ12005WH/PLZ20005WH