Command (function search)
Load condition settings
Operation mode
| FUNC | Sets the operation mode |
|---|---|
| FUNC:CVOP | Enables/disables +CV mode |
Range
| COND:RANG | Sets the conductance range |
|---|
Setting values
| COND | Sets the conductance |
|---|---|
| CURR | Sets the current |
| POW | Sets the power |
| VOLT | Sets the voltage |
Slew rate
| CURR:SLEW | Sets the slew rate |
|---|
Soft start
| CURR:SST | Sets the soft start time |
|---|
Response speed
| ARB:RESP | Sets the response speed in ARB mode |
|---|---|
| COND:RESP | Sets the response speed in CR mode |
| VOLT:RESP | Sets the response speed in CV mode |
Pulse
| COND:PULS:LEV | Sets the pulse conductance |
|---|---|
| CURR:PULS:LEV | Sets the pulse current |
| COND:PULS:FREQ | Sets the pulse frequency |
| CURR:PULS:FREQ | |
| COND:PULS:DCYC | Sets the pulse duty cycle |
| CURR:PULS:DCYC |
Sine
| CURR:SINE:AMPL | Sets the amplitude of the sine function |
|---|---|
| CURR:SINE:FREQ | Sets the frequency of the sine function |
Cutoff
| INP:CUTO:CAP OUT:CUTO:CAP |
Sets the integrated current of the cutoff function. |
|---|---|
| INP:CUTO:CAP:STAT OUT:CUTO:CAP:STAT |
Enables or disables the cutoff function for the integrated current. |
| INP:CUTO:ENER OUT:CUTO:ENER |
Sets the integrated power of the cutoff function. |
| INP:CUTO:ENER:STAT OUT:CUTO:ENER:STAT |
Enables or disables the cutoff function for the integrated power. |
| INP:CUTO:ETIM OUT:CUTO:ETIM |
Sets the elapsed time of the cutoff function. |
| INP:CUTO:ETIM:STAT OUT:CUTO:ETIM:STAT |
Enables or disables the cutoff function for the elapsed time. |
| INP:CUTO:VOLT OUT:CUTO:VOLT |
Sets the voltage drop of the cutoff function. |
| INP:CUTO:VOLT:STAT OUT:CUTO:VOLT:STAT |
Enables or disables the cutoff function for the voltage drop. |
Remote sensing
| SYST:CONF:RSEN | Enables/disables remote sensing |
|---|
Electronic Load PLZ12005WH/PLZ20005WH