PROG:CVOP:LEV

Sets the +CV (addition of CV mode) voltage in the program selected by PROG.

+CV mode can only be set with an SCPI command. This command is available to maintain compatibility with the PLZ-5W series (PLZ205W/PLZ405W/PLZ1205W).

If +CV mode is enabled, the UVP action (PROGram:VOLTage:PROTection:ACTion) is set to LIMit. The LIMit value changes according to the changes in the voltage (VOLTage) in CV mode.

If +CV mode is disabled, the UVP action is set to TRIP.

Command

[SOURce:]PROGram[:SELected]:CVOPtion:LEVel <numeric>

[SOURce:]PROGram[:SELected]:CVOPtion:LEVel?

Parameter <numeric>

Response

Returns the +CV voltage in the selected program in NR3 format in response to the PROG:CVOP:LEV? query.