Command (Sub-system search)
OUTPut/INPut subsystem
| INP OUTP |
Sets load on/off. Only when load is set to on, the duration to keep the load turned on can be specified. |
|---|---|
| INP:CUTO:CAP OUT:CUTO:CAP |
Sets the integrated current of the cutoff function. |
| INP:CUTO:CAP:STAT OUT:CUTO:CAP:STAT |
Enables or disables the cutoff function for the integrated current. |
| INP:CUTO:ENER OUT:CUTO:ENER |
Sets the integrated power of the cutoff function. |
| INP:CUTO:ENER:STAT OUT:CUTO:ENER:STAT |
Enables or disables the cutoff function for the integrated power. |
| INP:CUTO:ETIM OUT:CUTO:ETIM |
Sets the elapsed time of the cutoff function. |
| INP:CUTO:ETIM:STAT OUT:CUTO:ETIM:STAT |
Enables or disables the cutoff function for the elapsed time. |
| INP:CUTO:VOLT OUT:CUTO:VOLT |
Sets the voltage drop of the cutoff function. |
| INP:CUTO:VOLT:STAT OUT:CUTO:VOLT:STAT |
Enables or disables the cutoff function for the voltage drop. |
| INP:EXT:LOG OUTP:EXT:LOG |
Sets the signal logic for external control input |
| INP:MSYN OUTP:MSYN |
Synchronizes the load on/off operation on synchronized PLZ12005WH/PLZ20005WHs |
| INP:MSYN:ACC OUTP:MSYN:ACC |
Sets whether to accept load on/off sync signal (IMP:MSYN) input from other synchronized devices |
| INP:PON:STAT OUTP:PON:STAT |
Sets the panel setting state at power-on |
| INP:PROT:CLE OUTP:PROT:CLE |
Clears the protection mode |
| INP:PROT:WDOG OUTP:PROT:WDOG |
Enables/disables the watchdog protection function |
| INP:PROT:WDOG:DEL OUTP:PROT:WDOG:DEL |
Sets the delay time of the watchdog protection function |
Electronic Load PLZ12005WH/PLZ20005WH