TRIG:ACQ:SOUR
Sets the trigger source for clearing sequence start trigger wait states.
Command
TRIGger:ACQuire:SOURce <character>
TRIGger:ACQuire:SOURce?
Parameter <character>
You can select from the available choices below.
| Value | IMMediate | Executes the measurement values when the Initiate key on the PLZ12005WH/PLZ20005WH front panel is pressed or when INIT:ACQ is received from a PC or the like. |
|---|---|---|
| BUS | Records the measurement values at the timing of software trigger (*TRG) application. The trigger is applied to both trigger systems: (1) sequence and step (TRANsient) and (2) measure (ACQuire). | |
| DIGITAL2 | Executes the measurement values at the timing at which a signal is input to pin 13 of the EXT CONT connector of the PLZ12005WH/PLZ20005WH (when SYST:CONF:DIGITAL2:DIR is set to INPut). | |
| TALink | If PROG:STEP<n>:TRIG:GEN is set to TALink, measured values are recorded during the step execution of the sequence. | |
| MSYNc | Executes the step when TRIG:ACQ:MSYN is received from a PC or the like. | |
| LOADOFF | Executes the sequence when the load is turned off. | |
| *RST transmission | IMMediate |
Example
TRIG:ACQ:SOUR DIGITAL2
Response
Returns the source of the trigger of the ACQuire subsystem in character format in response to the TRIG:ACQ:SOUR? query.
Electronic Load PLZ12005WH/PLZ20005WH