PROG:STEP<n>:TRIG:GEN
Sets whether to perform trigger output at the specified step of the program selected by PROG.
Command
[SOURce:]PROGram[:SELected]:STEP<n>:TRIGger:GENerate <character>[,<character>,<character>,<character>,<character>]
[SOURce:]PROGram[:SELected]:STEP<n>:TRIGger:GENerate?
Parameter <n>
| Value | Specifies the step number |
|---|---|
| Example | STEP1 |
Parameter <character>
If NONE is set, it cannot be specified at the same time as other setting values.
For all other setting values, up to 5 items can be set.
| Value | NONE | Trigger not generated |
|---|---|---|
| TRIGOUT | Trigger signal output to TRIGOUT pin | |
| DIGITAL0 | Trigger signal output to DIGITAL0 pin | |
| DIGITAL1 | Trigger signal output to DIGITAL1 pin | |
| DIGITAL2 | Trigger signal output to DIGITAL2 pin (When I/O is OUTPut) | |
| TALink | Output TALink triggers. If TRIG:ACQ:SOUR is set to TALink, measured values are recorded during the step execution of the sequence. |
Example
PROG:STEP1:TRIG:GEN TRIGOUT,DIGITAL2,TAL
Response
Returns the trigger output setting at the specified step in character format in response to the PROG:STEP<n>:TRIG:GEN? query.
Electronic Load PLZ12005WH/PLZ20005WH