Command (Function)
Measurement Condition
Operation Mode
FUNC | Sets the operation mode |
---|
Setting of the range
COND:RANG | Set the range of conductance |
---|---|
CURR:RANG | Set the range of current |
POWER:RANG | Set the range of power |
VOLT:RANG | Set the range of voltage |
Input the setting value
COND | Set the conductance (CR mode) |
---|---|
CURR | Set the current |
POW | Set the power |
VOLT | Set the voltage |
Setting of the soft start
FUNC:SST | Set the soft start time |
---|
Setting of the short function
INP:SHOR OUTP:SHOR |
Turns ON/OFF the short function |
---|
Setting of the transient response speedv
FUNC:RESP | Set the transient response speed for PLZ-4W/ PLZ-4WH |
---|---|
FUNC:RESP:CR | Set the transient response speed for CR mode of PLZ-4WL |
FUNC:RESP:CV (PLZ-4WL) | Set the transient response speed for CV mode of PLZ-4WL |
FUNC:RESP:CV (PLZ-4WH) | Set the transient response speed for CV mode of PLZ-4WH |
Settingg of the switching function
PULS:LEV:COND | Set the conductance level |
---|---|
PULS:LEV:PERC:COND | Set the conductance level in terms of a percentage of the setting |
PULS:LEV:CURR | Set the current level |
PULS:LEV:PERC:CURR | Set the current level in terms of a percentage of the setting |
PULS | Turns ON/OFF the switching mode |
PULS:DCYC | Set the switching duty cycle |
PULS:PER | Set the pulse period |
PULS:FREQ | Set the pulse frequency |
Setting of the slew rate
CURR:SLEW | Set the slew rate |
---|
Setting of the cutoff time
INP:TIM OUTP:TIM |
Set the cutoff time |
---|
Setting of the count time
FUNC:CTIM | Turns ON/OFF the count time |
---|