Processing time of main commands
The command processing time is the time until the next command is accepted.
It does not include the response time of the hardware.
The processing times indicated here are typical values.
They are not warranted.
Command | GPIB*1 Processing Time(ms) |
USB Processing Time(ms) |
RS232C*2 Processing Time(ms) |
Description |
---|---|---|---|---|
*IDN? | 10 | 6 | 31 | Queries the model name |
*RST | 879 | 879 | 838 | Performs a device reset |
CURR 1 | 20 | 20 | 20 | Current setting |
CURR? | 8 | 7 | 20 | Queries the current setting |
MEAS:CURR? | 9 | 7 | 19 | Queries the current value |
MEAS:VOLT? | 9 | 7 | 19 | Queries the voltage value |
MEAS:POW? | 9 | 7 | 18 | Queries the powervalue |
CURR:RANG? | 9 | 7 | 17 | Queries the current range setting |
CURR:RANG LOW | 44 | 43 | 48 | Current range setting |
*1: Using USB-GPIB by National Instruments.
*2: Data rate setting: 19200 bps. X-Flow control: XFLOW.