Command (Sub-system)
PROGram subsystem
PROGram:CLEar | Delete the contents of the sequence |
---|---|
PROGram:CHAin | Set the number of the program to be executed next |
PROGram:CRANge | Set the current range |
PROGram:EXECuting | Query the number of the program currently in operation |
PROGram:FSPeed:EDIT | Edit an existing step (fast sequence) |
PROGram:FSPeed:EDIT:LINear | Set the FILL function (fast sequence) |
PROGram:FSPeed:EDIT:WAVE | Edit the waveform of the step (fast sequence) |
PROGram:FSPeed:END | Set the end step (fast sequence) |
PROGram:FSPeed:TIME | Set the step execution time (fast sequence) |
PROGram:LINPut | Set the load on/off condition after the sequence ends |
PROGram:LOOP | Set the number of program loops |
PROGram:LOUT | Set the load on/off condition after the sequence ends |
PROGram:LVALue | Set the setting value after the specified program ends |
PROGram:MEMO | Set the memo |
PROGram:MODE | Set the mode |
PROGram:NAME | Specify the program number |
PROGram:NSPeed:ADD | Add a step after the last step (normal sequence) |
PROGram:NSPeed:COUNt | Query the number of steps (normal sequence) |
PROGram:NSPeed:DELete | Delete the selected program sequence step (normal sequence) |
PROGram:NSPeed:DELete:ALL | Deletes the all the steps (normal sequence) |
PROGram:NSPeed:EDIT | Edit an existing sequence step (normal sequence) |
PROGram:NSPeed:INSert | Insert a normal sequence step (normal sequence) |
PROGram:STATe | Execute the selected program |
PROGram:VRANge | Set the voltage range |