Command (Function)
Protection and Clear the Alarm
Setting of the overcurrent protection
| CURR:PROT | Set the overcurrent protection |
|---|---|
| CURR:PROT:ACT | Sets whether to turn off the load or limit the current when the OCP trips |
Setting of the overpower protection
| POW:PROT | Set the overpower protection |
|---|---|
| POW:PROT:ACT | Sets whether to turn off the load or limit the power when the OPP trips |
Setting of the undervoltage protection
| VOLT:PROT:STAT | Turns ON/OFF the undervoltage protection |
|---|---|
| VOLT:PROT:UND | Set the undervoltage protection |
| VOLT:RANG | Set the range of voltage |
Clear the alarm
| INP:PROT:CLE OUTP:PROT:CLE |
Clear the alarm |
|---|