VOLT:OFFS:PROT:LEV:LOW (PCR-LE/ PCR-LE2 only)
Sets the UVP value used to judge averaged voltage measurements.
This command is valid in DC mode and AC+DC mode (OUTP:COUP DC|ACDC).
During single-phase, three-wire output (PCR-LE optional), set the voltage using phase voltage of the U phase.
Command
[SOURce:]VOLTage:OFFSet:PROTection:LEVel:LOWer {<numeric>|MINimum|MAXimum}
[SOURce:]VOLTage:OFFSet:PROTection:LEVel:LOWer? [{MINimum|MAXimum}]
Parameter
| Value | -474.1 to 474.1 (-474.1 by default) An SCPI error (-222, "Data out of range") occurs if the specified value is outside the range. |
| Unit | V |
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
Response
Response
Returns the UVP value in NR3 format in response to VOLT:OFFS:PROT:LEV:LOW?.
AC Power Supply PCR-LE series