VOLT:LIM:LOW
Sets the lower limit value of DC voltage.
This command is valid in AC mode and AC+DC mode (OUTP:COUP AC|ACDC).
If the EX05-PCR-LE is in use (optional) and the signal source is set to external signal source (FUNC:SOUR EXT), this command is invalid.
Command
[SOURce:]VOLTage[:LEVel]:LIMit:LOWer {<numeric>|MINimum|MAXimum}
[SOURce:]VOLTage[:LEVel]:LIMit:LOWer? [{MINimum|MAXimum}]
Parameter
| Value | 135V range: 0 to 137.5 （0 by default） 270Vrange: 0 to 275.0 （0 by default） A SCPI error (-222, "Data out of range") occurs if outside the range. |
0 to 305.0 （0 by default） A SCPI error (-222, "Data out of range") occurs if outside the range. |
| Unit | V |
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
Response
Response
Returns the lower limit setting of DC voltage in NR1 format in response to VOLT:OFFS:LIM:LOW?.
AC Power Supply PCR-LE series