VOLT:LIM
Sets the upper limit value of DC voltage.
This command is valid in AC mode and AC+DC mode (OUTP:COUP AC|ACDC).
If the EX05-PCR-LE is in use (optional) and the signal source is set to external signal source (FUNC:SOUR EXT), this command is invalid.
Command
[SOURce:]VOLTage:LIMit[:UPPer] {<numeric>|MINimum|MAXimum}
[SOURce:]VOLTage:LIMit[:UPPer]? [{MINimum|MAXimum}]
Parameter
| Value | 0 to 275.0 (275.0 by default) A SCPI error (-222, "Data out of range") occurs if outside the range. |
0 to 305.0 (305.0 by default) A SCPI error (-222, "Data out of range") occurs if outside the range. |
| Unit | V |
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
Response
Response
Returns the upper limit setting of DC voltage in NR3 format in response to VOLT:LIM?.
AC Power Supply PCR-LE series