MEAS:VOLT:AMPL:MAX/ FETC:VOLT:AMPL:MAX
MEAS:VOLT:AMPL:MAX? starts a new measurement and then queries the peak voltage.
FETC:VOLT:AMPL:MAX? queries the peak voltage without starting a new measurement.
All modes (parameters to the OUTP:COUP command) are valid.
Command
MEASure[0][:SCALar]:VOLTage:AMPLitude:MAXimum?
FETCh[0][:SCALar]:VOLTage:AMPLitude:MAXimum?
Response
Returns the peak voltage in NR3 format in response to MEAS:VOLT:AMPL:MAX? or FETC:VOLT:AMPL:MAX?.
In case of the single-phase three-wire output, MEAS:VOLT:AMPL:MAX? or FETC:VOLT:AMPL:MAX? returns a comma-separated list of the peak voltage <NR3> for U and V phases.
In case of the three-phase output, MEAS:VOLT:AMPL:MAX? or FETC:VOLT:AMPL:MAX? returns a comma-separated list of the peak voltage <NR3> for U, V, and W phases.
Unit：V
AC Power Supply PCR-LE series