MEAS:VOLT:AC/ FETC:VOLT:AC
MEAS:VOLT:AC? starts a new measurement and then queries the AC voltage.
FETC:VOLT:AC? queries the AC voltage without starting a new measurement.
The valid modes (parameters to the OUTP:COUP command) are AC, ACDC, EAC (PCR-M only), and EDC (PCR-M only).
Command
MEASure[0][:SCALar]:VOLTage:AC?
FETCh[0][:SCALar]:VOLTage:AC?
Response
Returns the AC voltage in NR3 format in response to MEAS:VOLT:AC? or FETC:VOLT:AC?.
In case of the single-phase three-wire output, MEAS:VOLT:AC? or FETC:VOLT:AC? returns a comma-separated list of the AC voltage <NR3> for U and V phases.
In case of the three-phase output, MEAS:VOLT:AC? or FETC:VOLT:AC? returns a comma-separated list of theAC voltage <NR3> for U, V, and W phases.
Unit：V
AC Power Supply PCR-LE series