MEAS:POW:AC:PFAC/ FETC:POW:AC:PFAC
MEAS:POW:AC:PFAC? starts a new measurement and then queries the AC power factor.
FETC:POW:AC:PFAC? queries the AC power factor without starting a new measurement.
The valid modes (parameters to the OUTP:COUP command) are AC, ACDC, EAC (PCR-M only), and EDC (PCR-M only).
Command
MEASure[0][:SCALar]:POWer:PFACtor?
FETCh[0][:SCALar]:POWer:PFACtor?
Response
Returns the AC power factor in NR3 format in response to MEAS:POW:AC:PFAC? or FETC:POW:AC:PFAC?.
In case of the single-phase three-wire output, MEAS:POW:AC:PFAC? or FETC:POW:AC:PFAC? returns a comma-separated list of the AC power factor <NR3> for U and V phases.
In case of the three-phase output, MEAS:POW:AC:PFAC? or FETC:POW:AC:PFAC? returns a comma-separated list of the AC power factor <NR3> for U, V, and W phases.
AC Power Supply PCR-LE series