MEAS:CURR:HARM:RAT/ FETC:CURR:HARM:RAT
MEAS:CURR:HARM:RAT? starts a new measurement and then queries the harmonic currents (as percentages).
FETC:CURR:HARM:RAT? queries the harmonic currents (as percentages) without starting a new measurement.
This command is invalid in single-phase three-wire output or three-phase output (PCR-LE optional).
If the EX05-PCR-LE is in use (optional), this command is valid when the signal source is set to internal signal source (FUNC:SOUR INT).
The valid mode (parameter to the OUTP:COUP command) is AC.
Command
MEASure[0][:SCALar]:CURRent:HARMonic:RATio?
FETCh[0][:SCALar]:CURRent:HARMonic:RATio?
Response
Returns the harmonic currents, from the first to the fortieth, (as percentages) in a comma-separated list of values in NR3 format in response to MEAS:CURR:HARM:RAT? or FETC:CURR:HARM:RAT?.
AC Power Supply PCR-LE series