MEAS:CURR:AMPL:MAX/ FETC:CURR:AMPL:MAX
MEAS:CURR:AMPL:MAX? starts a new measurement and then queries the peak current.
FETC:CURR:AMPL:MAX? queries the peak current without starting a new measurement.
All modes (parameters to the OUTP:COUP command) are valid.
Command
MEASure[0][:SCALar]:CURRent:AMPLitude:MAXimum?
FETCh[0][:SCALar]:CURRent:AMPLitude:MAXimum?
Response
Returns the peak current in NR3 format in response to MEAS:CURR:AMPL:MAX? or FETC:CURR:AMPL:MAX?.
In case of the single-phase three-wire output, MEAS:CURR:AMPL:MAX? or FETC:CURR:AMPL:MAX? returns a comma-separated list of the peak current <NR3> for U and V phases.
In case of the three-phase output, MEAS:CURR:AMPL:MAX? or FETC:CURR:AMPL:MAX? returns a comma-separated list of the peak current <NR3> for U, V, and W phases.
Unit:A