MEAS:CURR:AC/ FETC:CURR:AC
MEAS:CURR:AC? starts a new measurement and then queries the AC current.
FETC:CURR:AC? queries the AC current without starting a new measurement.
The valid modes (parameters to the OUTP:COUP command) are AC, ACDC, EAC (PCR-M only), and EDC (PCR-M only).
Command
MEASure[0][:SCALar]:CURRent:AC?
FETCh[0][:SCALar]:CURRent:AC?
Response
Returns the AC current in NR3 format in response to MEAS:CURR:AC? or FETC:CURR:AC?.
In case of the single-phase three-wire output, MEAS:CURR:AC? or FETC:CURR:AC? returns a comma-separated list of the AC current <NR3> for U and V phases.
In case of the three-phase output, MEAS:CURR:AC? or FETC:CURR:AC? returns a comma-separated list of the AC current <NR3> for U, V, and W phases.
Unit：A
AC Power Supply PCR-LE series