MEAS{1|2}:VOLT:DC/ FETC{1|2}:VOLT:DC
MEAS{1|2}:VOLT:DC? starts a new measurement and then queries the DC voltage of the specified phase.
FETC{1|2}:VOLT:DC? queries the DC voltage of the specified phase without starting a new measurement.
This command is valid in single-phase three-wire output (PCR-LE optional).
The valid modes (parameters to the OUTP:COUP command) is DC.
Command
U phase
MEASure1[:SCALar]:VOLTage:DC?
FETCh1[:SCALar]:VOLTage:DC?
V phase
MEASure2[:SCALar]:VOLTage:DC?
FETCh2[:SCALar]:VOLTage:DC?
Response
Returns the DC voltage of U phase in NR3 format in response to MEAS1:VOLT:DC? or FETC1:VOLT:DC?.
Returns the DC voltage of V phase in NR3 format in response to MEAS2:VOLT:DC? or FETC2:VOLT:DC?.
Unit: V
AC Power Supply PCR-LE series