MEAS{1|2|3}:POW:AC:PFAC/ FETC{1|2|3}:POW:AC:PFAC
MEAS{1|2|3}:POW:AC:PFAC? starts a new measurement and then queries the AC power factor of the specified phase.
FETC{1|2|3}:POW:AC:PFAC? queries the AC power factor of the specified phase without starting a new measurement.
This command is valid in single-phase three-wire output or three-phase output (PCR-LE optional).
The valid modes (parameters to the OUTP:COUP command) is AC.
Command
U phase
MEASure1[:SCALar]:POWer:PFACtor?
FETCh1[:SCALar]:POWer:PFACtor?
V phase
MEASure2[:SCALar]:POWer:PFACtor?
FETCh2[:SCALar]:POWer:PFACtor?
W phase (Three-phase output only)
MEASure3[:SCALar]:POWer:PFACtor?
FETCh3[:SCALar]:POWer:PFACtor?
Response
Returns the AC power factor of U phase in NR3 format in response to MEAS1:POW:AC:PFAC? or FETC1:POW:AC:PFAC?.
Returns the AC power factor of V phase in NR3 format in response to MEAS2:POW:AC:PFAC? or FETC2:POW:AC:PFAC?.
Returns the AC power factor of W phase in NR3 format in response to MEAS3:POW:AC:PFAC? or FETC3:POW:AC:PFAC?.
AC Power Supply PCR-LE series