DISP:LVOL
Switches the voltage display (between phase voltage and line voltage).
This command is valid in single-phase three-wire output or three-phase output (PCR-LE optional).
If the EX05-PCR-LE is in use (optional), this command is valid when the signal source is set to internal signal source (FUNC:SOUR INT).
Command
DISPlay:LVOLtage[:STATe] {ON|OFF|1|0}
DISPlay:LVOLtage[:STATe]?
Parameter
| Value | ON(1) | Line voltage is displayed. |
| OFF(0) | Phase voltage is displayed (default). |
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
For the setting that is applied when *RST is sent, see this table
Response
Response
Returns the voltage display in NR1 format in response to DISP:LVOL?.
AC Power Supply PCR-LE series