Interface Setup
Interface Setup for PCR-M series
GPIB （optional）
This interface is valid only when the optional GPIB interface board is installed. This product does not use the dip switches that are installed in the IB21.
GPIB connection
Use a standard IEEE488 cable to connect the PCR-M to the computer.
GPIB configuration
1. Press CONFIG until the interface is set to "IntF."
2. Turn the rotary knob to set GPIB to "488."
3. Press CONFIG to set the GPIB display to "GPIb."
Turn the rotary knob to select the GPIB address (1 to 30).
4. Wait at least 5 seconds, and then turn the POWER switch off and on.
The settings are applied.
GPIB function
| Function | Subset | Description |
|---|---|---|
| Source handshaking | SH1 | Full capability |
| Acceptor handshaking | AH1 | Full capability |
| Talker | T6 | Function available |
| Listener | L4 | Function available |
| Service request | SR1 | Full capability |
| Remote local | RL1 | Full capability |
| Parallel polling | PP0 | No capability |
| Device clear | DC1 | Full capability |
| Device trigger | DT1 | Full capability |
| Controller | C0 | No capability |
| Electrical interface | E1 | Open collector driver |
Service request
Service request and serial polling functions are implemented.
AC Power Supply PCR-LE series